xTool - Black Laser Marking Spray

Compatible with CO2 (25-watt minimum), Diode (10-watt minimum), and Fiber (10-watt) lasers. Easy and quick to use, just simply spray and engrave to create black marks.

Shake the bottle for 2-5 minutes before use for best results. The best spraying distance is 6-8 inches. After spraying, dry at room temperature for 10-30 minutes, or use a heat gun to speed up drying. The spray should be completely dry before engraving with the xTool machines. Remove any remaining marking spray with water and a rag after engraving.

Please Note: The spray is initially white in color, but will turn black after laser engraving. It can help the Blue-light Laser to achieve engraving on glass, but the glass will not show a black effect when engraving is used on it.

Please Note that if you don't use it all at once, be sure to clean the valve by turning the can upside down and pressing the nozzle until only gas comes out after use. The next time you use it, it will not be clogged to avoid the situation of not being able to spray. You can avoid possible leaks by shaking it a few times after each use and pressing the nozzle a couple of times to get any powder that may be attached to the gasket inside the valve out.